Camshaft Position Sensor 'B' Circuit Intermittent

When I come to a stop, either at a red light or stop sign, and I have my foot on the brake, and come to a complete stop. The engine would idle rough and then would either die on me, or if I have time, I would put the driver selector switch into neutral and give it some gas before the engine quits. I have a OBD2 reader for my IPad, and when this happens, usually the codes P0365, or P0369 occur. I have had my truck into the shop numerous times to get fixed, and they have replaced the Cam Sensor for those P0365, and P0369 codes, but the problem still exists.

Low oil pressure light came on and engine making loud noise. Had towed to Way Brothers Ford in Hawkinsville GA 183 BROAD STREET HAWKINSVILLE GA 31036 PHONE 478-892-9141. Original diagnostic check on day vehicle failed [XXX]: "diag found code p0365 p0369 found oil pump belt broken necessary to remove and replace engine..." On repair invoice when engine was replaced [XXX]: "engine oil pump belt loose causing the engine to lose oil pressure; engine has internal damage; low on compression". I HAVE PAID A TOTAL OF $3,775 TO REPAIR THE VEHICLE AND THE DEALER STATES THEY HAVE NOT RECEIVED ANYTHING FROM THEIR CORPORATE OFFICE REGARDING REIMBURSING THIS COST SO THEY ARE REFUSING TO REIMBURSE THE COST…

My engine check light came on and it said Engine Fault Service Now, with a wrench signal exposed. Then I could hardly stop the vehicle , it became very difficult to apply the brakes, using all of my body weight applied to stop the vehicle. I immediately brought it to O’Reily’s auto place and had a diagnostic test run on the vehicle. Multiple default code come up. P1016, p0365, p0299,p164D p0369,p0443,p0456,p1450. Brought it to the Ford dealership, upon inspection the diagnosis Evap system related disc on this line , tested evap system, found canister purge valve to be broken , tech notes that this is a non Oem part. Advised to replace purge valve and hose assembly. Also discovered that…

MY VEHICLE HAS BEEN IN THE DEALERSHIP APPROX. FOUR TIMES, BECAUSE THE SERVICE ENGINE LIGHT COMES ON, FOLLOWED BY THE TRACTION CONTROL LIGHT. THEY SAID THAT THE CABLE CONNECTION GETS LOOSE AND THEY SOLDERED IT. THIS STARTED ABOUT 20000 MILES AND IS NOW AT 57778 MILES. THIS LAST TIME ON 4-24-2019 THEY SAID THAT IT HAS STORED CODES FOR THE CAM SENSORS ON BOTH BANKS AND TORQUE REQUEST DENIED SIGNAL AND TORQUE MANAGEMENT SIGNAL PERFORMANCE. P2638, C121C, P0344, P0369. THEY SAID THAT IT HAS PCM UPDATE AND THAT THEY PERFORMED THE PCM UPDATE AGAIN AND CLEARED CODES TO SEE IF THEY WOULD COME BACK. VEHICLE DRIVEN 30 MILES AND AND ONE LARGE BUMP IN THE ROAD AND THE LIGHTS TURNED ON AGAIN. THIS HAPPENS…

1) Check engine light appears and engine loses power when going up inclines on highway (bridge, hill, etc.) Cruise control shuts off involuntarily and even if you push the gas pedal to the floor, the vehicle decelerates. This causes a safety issue every time as cars in other lanes are swerving around me as I haven't enough power to adequately climb the hill. Dealer service dept says it's most likely a camshaft issue, based on their diagnostic code P0369. This started happening @ 65,000 miles - ridiculously early for such a major engine repair. My own mechanic says this is a known issue with Chrysler Town & Country, yet FCA refuses to stand behind their product. 2) Blind spot sensor failed @…

TAKATA RECALL ENGINE STALLING GIVING CODE P0369 AND P0365 CAM SHAFT POSITION SENSOR BANK 1. VERY DANGEROUS AS CAR WILL STALL WHEN DRIVING WITHOUT NOTICE AND COULD LEAD TO A VERY BAD ACCIDENT. TOOK IT TO SHOP TWICE SAME ISSUE..

I own a 2019 Ford Expedition with fewer than 100,000 miles equipped with the 3.5L EcoBoost engine. The vehicle began experiencing a loud cold-start rattle, engine timing issues, and check engine light illumination. The vehicle was diagnosed by a Ford dealership with internal VCT/cam phaser mechanical failure affecting engine timing and performance. The dealership diagnostic identified trouble codes P0016, P0365, and P0369. The dealership also documented that the engine oil level and condition were within specification, indicating the failure was not caused by lack of maintenance or neglect. The dealership recommended replacement of all four VCT units and four VCT solenoids due to internal…

I own a 2019 Ford Expedition with fewer than 100,000 miles equipped with the 3.5L EcoBoost engine. The vehicle began experiencing a loud cold-start rattle, engine timing issues, and check engine light illumination. The vehicle was diagnosed by a Ford dealership with internal VCT/cam phaser mechanical failure affecting engine timing and performance. The dealership diagnostic identified trouble codes P0016, P0365, and P0369. The dealership also documented that the engine oil level and condition were within specification, indicating the failure was not caused by lack of maintenance or neglect. The dealership recommended replacement of all four VCT units and four VCT solenoids due to internal…

I am writing to notify Ford Motor Company, hereinafter referred to as “Ford” of the 2019 Ford F-150, King Ranch edition, VIN Number [XXX] (the “Vehicle’) recurring engine failure, hereinafter referred to as “Manufacturer Defect”. The Manufacturer Defect has continuously put my family in LIFE-THEATENING SITUATIONS. I purchased the Vehicle from Texas Ford Sales Ltd., Dealer Number P11422 on April 13, 2019. The Vehicle was taken to AutoNation Ford of Fort Worth, hereinafter referred to as “AutoNation” to seek warranty repairs for the Manufacturer Defect. The Vehicle has been in AutoNation and Ford’s care, custody, and control for more than 50 days relating directly to the Manufacturer Defect…

VEHICLE EXPERIENCED A LOSS OF POWER GOING INTO SORT OF A LIMP MODE / LOW POWER MODE, INDICATED LOW ENGINE OIL PRESSURE ON THE DASH STATUS DISPLAY WITH A WRENCH LIGHT AND INCREASED ENGINE NOISE. DRIVER WAS ABLE TO GET THE VEHICLE OFF THE ROAD WITHOUT AN ACCIDENT OCCURING. THE ENGINE CODES SCANNED VIA THE OBDII PORT DIRECTLY AFTER ARE AS FOLLOWS: P051B, P0299, P0340, P0344, P0365 AND P0369. THE TAG/STICKER ON THE TOP OF THE MOTOR HAS THE FOLLOWING NUMBERS, DATE AND INFORMATION ON IT: H2BG 6L084 AA 1,01 427 CRAIOVA ENGINE PLANT 19JUL17 FWSTA19071410474H2BG 6L084 AA FE AFTER FINDING OUT ABOUT THE CURRENT RECALL CAMPAIGN 23S64 / 23V905 AND SPEAKING WITH A FORD REPRESENATIVE WHO RECOMENDED GETTING…