P228D fault code: what 9 owners reported

I bought this car 1 1/2 yr ago.. Thursday I was driving down the road no warning lights no sounds, it stalled.. I got it home by a friend towing it, and when I went to try to start it, I then had the check engine light come on, and it threw 3 codes.. P0017, P0089, P228D. I was told that the ecm was replaced but after researching this there has been multiple sites stating others are having same issue.. and some stating that their problem was fixed but it broke down again every time. I just want my car fixed. And the company should have to pay for it...

…SO I FINALLY GOT A CODE P228D COME UP AND I BEEN EXPLAINING TO AUTO SHOPS THAT'S SOMETHING WRONG BECAUSE IT'S NOT WANTING TO PICK UP SPEED. SO WHAT CAN I DO I'M TIRED SPENDING MONEY TO GET IT LOOKED AT AND ALL I'M GETTING FROM PEOPLE NOTHING IS WRONG WITH YOUR VEHICLE. BUT THERE IS TRULY SOMETHING WRONG WITH THIS VEHICLE AND IT DOES THIS NO MATTER WHERE I'M AT ON HIGHWAY, STREET, WHEN I'M IDLE IT'S A LOUD NOISE AND I CAN FEEL THE HEAT FROM THE ENGINE COMING THROUGH THE FLOOR OF MY VEHICLE

I had a message flash that said the power to the engine was reduce. Next message said check stabilink ( or something similar).. it said drive with caution. I live 2 mins from my job I drove home and pulled in the driveway I then felt the car act like it wanted to shake. This was on 2-10-26 I contacted onstar asked them to run a diagnostic. The codes that came back P0016 p0089 p228D are very well known codes with many people with the same vehicle/engine that have had to replace the engine. The engines have known issues had I known that maybe I could have replaced a part or two or three or four to have a stable vehicle now my vehicle is currently at GMC DEALER since Tuesday morning actually…

VEHICLE STALLED WHEN DRIVEN OR STOPPED AT TRAFFIC LIGHT. ABNORMAL NOISES COMING FROM ENGINE. WHEN ENGINE OIL WAS CHECKED, NO VISIBLE OIL WAS AVAILABLE IN THE DIPSTICK. INSERTED DIPSTICK A COUPLE OF TIMES TO ENSURE CORRECT MEASUREMENT. EXTREMELY LOW OIL LEFT IN VEHICLE. VEHICLE SEEMS TO BE BURNING OIL. DIAGNOSTIC TROUBLE CODES READ BY OBD2 TOOL WERE: P0011,P0191,P228D,P0089 AND P0014. WHEN INVESTIGATING ONLINE, THIS IS A COMMON PROBLEM WITH THE VEHICLE'S ENGINE. THIS SEEMS TO BE A DESIGN FLAW BEING IGNORED BY THE OEM.

TL* THE CONTACT OWNS A 2013 CHEVROLET MALIBU. WHILE THE VEHICLE WAS STOPPED AT A TRAFFIC LIGHT, IT BEGAN TO HESITATE AND THE CHECK ENGINE WARNING INDICATOR ILLUMINATED. THE VEHICLE WAS TOWED TO THE CONTACT'S RESIDENCE. THE CONTACT STATED THAT THE VEHICLE FAILED TO RESTART. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO FOUND THE FOLLOWING THREE CODES: P0089, P228D, AND P0016. THE VEHICLE WAS TAKEN TO KELLER MOTORS (LOCATED AT 700 CADILLAC LN, HANFORD, CA 93230, (866) 882-6546), BUT THEY WERE UNABLE TO DUPLICATE THE FAILURE. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED. THE FAILURE MILEAGE WAS 109,133. THE VIN WAS INVALID.

MY CAR OIL CONSUMPTION IS EXCESSIVE. I HAVE REPETITIVE CODES: P0089, P0300, P0366, P228D, P0014 AND THE CHECK ENGINE LIGHT BEING ON. CAR IS JERKING BACK AND FORTH WHEN AT A STOP LIGHT. TAPPING NOISE MADE ALSO. EVERY 1000-1500 MY CAR IS ALWAYS NEEDING OIL (AT LEAST 2 QUARTS) AND I ALSO HAVE TO PUT MORE THAN THE USUAL AMOUNT OF GAS IN IT THEN WHEN I FIRST PURCHASED.

I have had several codes pop up on my Equinox, such as P0016, P0017, P0089 and P228D. All of these codes are between the Crankshaft position, variable timing position and high pressure fuel issues. I almost wrecked my SUV because of these 3 factors and I have seen thousands of videos on YouTube with other people having the same issues. This is beyond dangerous to be out on the road driving and these codes pop up causing "Reduce Speed" warnings and "Stabilitrak". This will be the 2nd time I've had to replace the Crankshaft position sensor and Variable Timing Solenoid, along with a brand new timing kit that I had put on right after I bought the car over a year ago, that is now in need of…

2/3/2018, OUTSIDE TEMPERATURE WAS15DEGREES FAHRENHEIT . TRAVELING AT 65 MPH THEN SUDDENLY VEHICLE SLOWED AND A WARNING APPEARED ON THE DASH, "ENGINE POWER REDUCED" AND TWO WARNING LIGHTS, TRACTION AND ENGINE LIGHT. AS I PROCEEDED TO MY DESTINATION AN ENGINE OVER SPEED WARNING CAME ON SLOWING THE VEHICLE. VEHICLES IN THE REAR STARTED PASSING MY VEHICLE SINCE I COULD NOT MAINTAIN THE SPEED LIMIT. THIS INCIDENT WAS A BIT SCARY. TWO CODES WERE RETRIEVED VIA ON BOARD DIAGNOSTICS, P228D AND P0089. CODES WERE CLEARED AND THINGS SO FAR ARE OK. MILEAGE ON THE VEHICLE IS 48,683.

My engine failed. It's available for inspection upon request. The engine stalled in the middle of high traffic. I called GM customer care and explained to them what happened. They told me to take it to a GM dealership for diagnosis, (it was already diagnosed by a major company). The dealership confirmed a broken timing chain and bent valves. They also said that it was $12,000 to repair and that GM would only cover $1,200 since its out of drive train warranty. They request that I put down $8,657 before they could order a new engine. The codes the car gave were P0016, P0017, P228D, P0089, and P0341.